| Technische Details Crestron MP2: |
| Processor |
| CPU |
32-bit Motorola 5407 ColdFire®
Processor |
| Processing Speed |
257 MIPS (Dhrystone 2.1 benchmark) |
| Memory |
| 36 MB Total |
| Connectors |
| COM |
(2) DB9 for RS-232/422/485 |
| RELAYS |
(4) normally open, isolated
relays; each relay is rated 1A, 30VAC/DC; MOV arc suppression
across contacts for use with "real world" loads |
| INPUT |
(4) programmable digital/analog
inputs digital inputs rated for 0-24VDC, 20K ohms input impedance,
logic threshold 1.25VDC; analog inputs rated for 0-10VDC, protected
to 24VDC maximum, 20K ohms input impedance; programmable 2K
ohms pullup resistor (per pin, software reference to GND or
closure to GND) |
| IR ports |
4 programmable simultaneous
outputs for IR, TTL Level RS-232 or serial interface; signal
(ws) and ground (G) pins; infrared output up to 1.2MHz with
individual UART per port allowing simultaneous firing of all
ports |
| IR Receiver |
3-position mini-phoenix for
use with CNXRMIRD. Used to recognize RC-5 and Sanyo IR remote
controls. |
| Computer Port |
1 RS-232 port,9-Pin DB9 for
programming a PC |
| Cresnet Port |
1 4-Pin male connector |
| Power |
1-jack accepts 24VDC from PW-2420RU
power supply (included), passes power through to CresNET port |
| Video Switcher |
| 6BNC connectors implement a
4 x 2 composite video crosspoint or can be used as a 2 x 1 S-Video
crosspoint (Y/C). All inputs have video sensors built-in and
are 75 ohm terminated. Outputs are designed to drive 75 ohm
devices |
| Audio Switcher |
| 8 Mini screw terminal connectors
implement a 7 x 1 stereo audio crosspoint supporting balanced
and unbalanced audio in and out. A built-in stereo volume, bass
and treble control is included on the output as well as a 6-Band
parametric equalizer with user definable presets for all input
sources. |
| Reset Buttons |
| HW-R |
Performs physical reset of system |
| SW-R |
Restarts SIMPL program |
| LED Indicators |
| PWR |
Green LED, indicates power supplied
to the unit |
| NET |
Yellow LED, indicates activity
within the system |
| ERR |
Red LED, indicates an error
message is available from the software feature buttons |
| Power Requirements |
| External 24VDC, 2.0A2, 24W+
power jack or Cresnet connector; PW-2420RU Power Supply included |
